How To Repair Clean Trackpad On Macbook Air

• Before starting this procedure, you should disable your Mac's Auto Boot feature. Auto Kick powers on your Mac when you open the lid, and may be accidentally triggered during disassembly. Use this guide to disable Automobile Boot.

• If your MacBook is running Big Sur v11.ane or later, disabling Auto Kick may not piece of work. You lot can proceed normally, just make sure to disconnect the battery as before long as you're inside.

• Completely power off and unplug your MacBook before you start. Shut the display and flip the entire laptop upside-down.

• Use a P5 commuter to remove the following screws:

• Ii vii.ix mm screws

• Two vii.3 mm screws

• Six ii.6 mm screws

• Throughout this repair, continue track of each screw and make sure it goes back exactly where information technology came from to avert damaging your MacBook.

• Wedge your fingers between the brandish and the lower case and pull upwards to pop off the lower case.

• Remove the lower case.

• To reinstall the lower case:

• Prepare information technology in place and press firmly to engage the 2 hidden clips underneath. You should feel and hear them snap into place.

• Use the flat end of a spudger to pry upwards and unlatch the metallic locking arm on the bombardment connector.

• Make certain the metallic arm is completely free of the locking tab before lifting the battery connector. The metallic locking arm should easily unlatch.

• Lift direct upwards on the metallic locking arm to pull the battery connector out of its socket on the logic board.

• During reassembly, press the bombardment connector directly down into its socket, making sure it sits flush within the socket.

• Utilize a T3 Torx driver to remove the two i.four mm screws securing the trackpad cable encompass.

• If your T3 bit feels a chip besides loose, you may need to use a T4.

• Remove the trackpad cable encompass.

• Apply the apartment cease of a spudger to pry the trackpad cable connector up and out of its socket.

• Carefully peel the trackpad cable off of the bombardment.

• The trackpad cablevision is secured to the battery with some light agglutinative.

• Utilise a pair of tweezers to peel back the tape roofing the trackpad cable connector.

• Use the pointed terminate of a spudger to lift upwardly the small locking flap on the trackpad cable'south ZIF connector.

• Slide the microphone cablevision out of its connector.

• If possible, grip the cablevision by the tape, not past the cablevision itself.

• Utilize a T5 Torx driver to remove the nine screws securing the trackpad:

• Eight fully-coated 3.1 mm screws

• One partially-coated iii.1 mm screw

• While keeping the laptop screen-side down, advisedly open up the laptop. The trackpad will stay sitting on the brandish.

• Every bit you lift, make sure the trackpad cable threads through the opening on the case.

• As you remove the trackpad associates, be careful non to lose the five small metal washers resting on the screw posts. (They will fly off and go lost with very trivial provocation.)

• Remove the trackpad.

• Take extra intendance to not scratch the display.

• If your replacement trackpad comes with a trackpad cable preinstalled, this step isn't necessary.

• Utilise the flat stop of a spudger to lift the small locking flap on the trackpad's ZIF connector.

• Slide the trackpad cable straight out of the ZIF connector.

Source: https://www.ifixit.com/Guide/MacBook+Air+13-Inch+Late+2020+Trackpad+Replacement/142561

Posted by: hodgesrepia1985.blogspot.com

Share this post